CNC Machinist

Local mechanical systems manufacturer in N Tonawanda, NY looking for a skilled CNC Machinist!!

1st shift hours 7:30am-4pm Mon-Fri + OT

Pay varies based on experience - $25-40/hr

Direct hire opportunity

Please reply with resume for immediate consideration!!

REQUIREMENTS:

• 2-3 years setup & operation experience of large vertical turning centers and smaller mills/lathes
• Experience writing and coding programs preferred but not required
• 3-5 years relevant experience (experience in “job shop” environment preferred)
• Ability to read/interpret engineered drawings and willingness to interface with engineering department
• Must be proficient with measuring equipment
• Strong mechanical aptitude & math skills required
• Rigging experience a plus

JOB DUTIES:

• Program mills or lathes by building & entering instructions (code), including all aspects of job set-up, calculations, tools, operating parameters and dimensional validation.
• Verify settings by measuring positions, first-run part, and sample workpieces; adhering to appropriate standards
• Maintain specifications by observing process & part quality; taking measurements; detecting malfunctions; troubleshooting processes; adjusting and reprogramming controls; sharpening and replacing worn tools; adhering to quality assurance procedures and processes.
• Perform set-up and tear down/clean-up of machining centers.
• Utilize measuring devices – including but not limited to micrometers, calipers, tape measure, scales, etc.
• Perform pre and post-machining inspections to verify critical fabrication or material tolerance requirements.
• Follow all lawful employer safety and health rules and regulations, and wear or use required protective equipment while working. Report hazardous conditions to the employer. Report any job-related injury or illness to the employer, and seek treatment promptly.