Description
Set up, adjust, and operate single or multiple saws and/or cutting machines to cut stock to length.
Requirements
Key Responsibilities:
Select and set machine automatic feed, speeds, for type of material cutting characteristics and to ensure production
standards and quality requirements are met
Load machines with multiple lengths of stock, as is standard operating procedure
May setup and operate two or more machines simultaneously as directed by supervisor
Diagnose machine malfunctions, setup and operating difficulties, causing deviations and make corrective adjustments
Work from drawings, specifications, charts, and layouts to ensure cut length tolerances are correct
Use proper inspection tooling to monitor tolerances
Complete all required paperwork accurately, attention to detail
Proceed under general supervision; guidance provided on new work or variations on the product line
Work is subject to process and final inspection and test
Keep work area clean and organized
Physical Requirements, General Working Environment:
Requires standing, lifting and bending
Proper lifting techniques, lift assist
Impact, crush, cut and pinch-point knowledge
Chemical exposure, SDS awareness
Seasonal warm, cold
Education:
High school graduate or GED equivalent
Attention to time management, results-oriented
On the job training, comprehension of machine operating procedures and adherence to safety protocols
Starting rate $17.50/hr., Experience Based